Blog
Fix the drip before the dry months. Here is the leaking faucet repair cost from 22 real jobs.
A dripping faucet feels like an annoyance. It is really a clue, and where the water shows up tells you what you’ll pay to fix it.
We've all been there with a faucet that drips from the spout after it is turned off. The handle might demand more and more force to stop it. Usually, the cause is a worn washer or a worn cartridge, the part inside the handle that opens and shuts the water.
But where the water shows up tells you which part is worn, and roughly what you will pay.
Where the water trickles from
If water's still dripping slowly from the spout despite turning it off completely, that means either a worn washer or cartridge. The cartridge itself is within the handle, and opens or shuts the water stream. A key clue is needing more and more force to stop it, once opened.
Likewise, if the water lands around the face of the faucet or handle, it's more probably the O-ring. This is a rubber or silicone seal that rings the spout or handle, keeping water from leaking out.
But if the water can be seen pooling under the sink, that's a different story. The angle valve, flexible supply hose, or even the P-trap are the more likely culprit. In these cases, it's not the faucet itself that's at fault.
Why does my faucet keep dripping even when I turn it off tight?
If you keep turning the handle and it still drips, the internal parts are likely worn. A washer or a cartridge inside the handle usually causes this. You will need more force to stop the drip because they have worn down. The water comes from the spout after you think it is off.
Why a drip matters more this dry season
A drip looks harmless. The US EPA says a faucet dripping once per second can waste more than 3,000 gallons a year, about as much water as 180 showers.
PAGASA expects way below to below normal rainfall in November, and less rainfall across the country until May 2027. You are advised to start storing and conserving water.
Our El Niño guide for the home covers the tank side, if you rely on one. But this is one of the cheapest water problems in the house to fix.
Leaking faucet repair cost: what 22 of our jobs closed at
You see a first number that looks fine on paper, but it rarely tells the whole story. 14 of those 22 closed above the first estimate of ₱850 to ₱1,200. The estimate assumes a simple fix, and that is where the trouble starts. The real cause shows up once the plumber opens the cabinet or takes the handle apart. That is why a photo before booking helps so much. A photo of the faucet and the pipes under the sink gives the plumber a clear head start.
Of the 22 sink and faucet leak repairs we've priced since August, 17 closed between ₱850 and ₱2,500 in labour. Replacing the whole faucet ran ₱700 to ₱2,000 in labour on 6 of our last 8 replacements, with the faucet itself on top. A leak inside the wall is quoted after an assessment, because nobody can price what they don't see yet; see the plumber page for what a visit covers.
Indicative Metro Manila ranges as of November 2026, based on KuyaYos booking data. Actual quotes depend on site assessment.
Should I repair or replace a leaking faucet?
A worn washer, cartridge or O-ring is a repair. A cracked body, heavy corrosion or a faucet that leaks again soon after a repair is usually a replacement. If the parts are worn out, you can fix them, or replace the faucet if the body is cracked.
Where the water lands is not where it starts. You see water travel along the pipe or the faucet body. The water falls at the lowest point. Your wet cabinet floor often comes from the angle valve or the supply hose above it. Look for the highest wet spot, not the puddle.
What needs to happen tonight
If the sink has a steady flow of water at this very moment, here's four steps you can take before calling a plumber. The sooner, the better.
First, place a dry towel or some kind of basin to catch the drip. Note how quickly the container fills, as this will indicate the severity of the leak.
Second, check for wet spots around the cabinet or on any nearby organic materials. These can lead to mold and should be scrubbed immediately.
Next, if the water is running, shut the angle valve off. This will also prevent water from reaching the faucet.
And finally, take a photo of the faucet and its nearby fixtures. This will ensure you can provide evidence to any plumber you book.
When it is time to call a plumber
A drip from the spout can wait a few days, but water pooling under the sink cannot be ignored. It might come from the angle valve on the wall pipe, the flexible supply hose, or the curved P-trap that holds water to block sewer smell. The faucet itself is not the source. A leak that returns soon after a repair also needs attention. A wet wall near the sink could mean a leak inside the wall, and that needs an assessment before anyone can price it. Our hidden leak guide has a meter test. You might need a plumber to look at it. You can watch the area for a day or two, but the hard stuff cannot wait.
Book through the link, attach the photos, and we send a plumber who checks the faucet and the pipes under the sink before giving a price. Every one has TESDA or equivalent certification, NBI clearance and verified work history, and if you do not like the first one or the quote, we re-match you with someone else for free.
So tap to book and get that leak sorted. No pun intended.